JTAG-HS2 Programming Cable

The joint test action group (JTAG) HS2 programming cable is a high-speed programming solution for AMD® field-programmable gate arrays (FPGAs). The cable is fully compatible with all AMD tools and can be seamlessly driven from iMPACT™, ChipScope™, and EDK. The HS2 attaches to target boards using Digilent's 6-pin, 100-mil spaced programming header or AMD's 2×7, 2mm connector and the included adaptor. 
The PC powers the JTAG-HS2 through the USB port and will recognize it as a Digilent programming cable when connected to a PC, even if the cable is not attached to the target board. The HS2 has a separate Vdd pin to supply the JTAG signal buffers. The high-speed 24mA three-state buffers allow target boards to drive the HS2 with signal voltages from 1.8V to 5V and bus speeds of up to 30MBit/sec. To function correctly, the HS2's Vdd pin must be tied to the same voltage supply that drives the JTAG port on the FPGA. 
The JTAG bus can be shared with other devices as systems hold JTAG signals at high-impedance except when actively driven during programming. The HS2 comes included with a standard Type-A to Micro-USB cable that attaches to the end of the module opposite the system board connector. The system board connector should hold the small and light HS2 firmly in place.
Note: This cable is not needed for Digilent FPGA boards as our boards are designed with this functionality natively.
To view our EMC Disclaimer, click here.

Analog Devices ADP123AUJZ Linear Regulator
Small, complete, all-in-one JTAG programming solution for AMD FPGAs
Compatible with all AMD tools
Compatible with IEEE 1149.7-2009 Class T0 – Class T4 (includes 2-Wire JTAG)
Separate Vref drives JTAG/SPI signal voltages; Vref can be any voltage between 1.8V and 5V.
High-Speed USB2 port that can drive JTAG/SPI bus at up to 30Mbit/sec
JTAG/SPI frequency settable by user
Uses micro-AB USB2 connector
SPI programming solution (modes 0 and 2 up to 30Mbit/sec, modes 1 and 3 up to 2Mbit/sec)
Fully supported by Digilent's Adept software and Adept SDK, allowing custom JTAG/SPI applications to be created

Product Compliance: 

HTC: 8471801000
ECCN: 3A992.a

One JTAG-HS2 Programming Cable.

Programming: Works with all AMD tools. Fully supported by Digilent's Adept SDK, allowing custom JTAG/SPI applications to be created.

Quickly find what you need to get started.
All product support including documentation, projects, and the Digilent Forum can be accessed through the product resource center.
Resource Center
Quick Links
Reference Manual

Aplikasi & Use Case: JTAG-HS2 Programming Cable mendukung kebutuhan integrasi sistem pengujian, aksesori pengukuran laboratorium, dan pemrosesan sinyal pada fasilitas riset dan industri.